How to Balance Narration and Background Music: LUFS and Ducking Basics
A common piece of feedback on videos is “the background music is so loud I can’t hear the voice.” The opposite happens too: the music is turned down so far that it feels like silence. This article walks through how to think about the volume balance between background music (BGM) and narration.
Volume Basics: Measure “Perceived Loudness” in LUFS
How loud something sounds isn’t determined by waveform peak height alone. The usual way to measure the loudness the human ear actually perceives is a unit called LUFS (loudness units relative to full scale). Video platforms such as YouTube normalize playback to roughly -14 LUFS (this varies somewhat by service and settings). If you master louder than that, the platform simply turns it down during playback, so “louder” doesn’t give you any advantage.
For the overall mix of your video (voice and music combined), the following guidelines make mistakes less likely:
- Voice-focused videos: aim for an overall level of around -16 to -14 LUFS.
- Music-focused videos (scenery, study/work BGM, and so on): aim for an overall level of around -14 LUFS.
Many video editors have a built-in loudness meter. If yours doesn’t, you can also export the video and load it into a free audio program to measure it.
How Much Lower Should the BGM Be Than the Voice?
Music placed under a voice should basically sit well below the voice. As a rule of thumb, set it about 10 to 20 dB lower than the voice. On a meter, if your voice moves around -12 dB, the BGM should sit roughly between -25 and -35 dB.
That said, it depends on the track:
- Tracks with a prominent melody clash with the voice in the same frequency range, so keep them even quieter.
- Tracks with few notes, such as Ambient or piano pieces, are less likely to get in the way of the voice, so they can be a little louder.
- Avoid putting music with vocals under speech. The lyrics and the spoken words will collide.
These numbers are only a starting point. In the end, listen on both a phone speaker and earbuds and check that the voice is clearly intelligible.
Ducking: Lower the BGM Only While Someone Is Speaking
If you leave the BGM at a constant low volume, scenes without speech feel empty. That’s where ducking comes in. The BGM is lowered (automatically or manually) only while the voice is present, then slowly brought back up when the voice stops.
Here’s the manual procedure:
- Set up the BGM track so you can place volume “keyframes” (points) on it.
- Start lowering the BGM about 0.5 seconds before the speech begins.
- When the speech ends, bring the volume back to its original level over about 1 second.
The trick is not to switch abruptly when lowering and raising the volume. A slope of 0.3 to 1 second sounds natural. Some software also has features that automatically lower the BGM based on the voice track (sidechain, auto ducking, and so on).
Common Mistakes
- Covering up the BGM level by adjusting your headphone volume. Keep your playback volume constant while editing and judge by the numbers on the meter.
- Setting the BGM level by listening to the BGM alone. Decide it with the voice layered on top.
- Not checking bass-heavy BGM on speakers. Low frequencies can’t be heard on a small phone speaker, so check in the environment where people will actually listen.
Summary
- Aim for an overall volume of around -14 LUFS.
- Keep BGM under a voice about 10 to 20 dB lower than the voice.
- Ducking, which lowers the music only while someone is speaking, gives you both clarity and atmosphere.
- Do your final check on a phone speaker and earbuds.
Otomusu tracks can be chosen by video genre. The loudness of each track is listed in LUFS in the “Sound Analysis” section of that track’s page.
Tracks mentioned in this article
Press ▶ to listen, or open a track to download it for free.
Terms of use for the assets
- Free
- No registration
- Commercial use OK
- Edits OK
- Credit optional
- No usage report needed
See the terms of use for details.
Related articles
- How to Add Sound Effects to Video: Scene Transitions, Emphasis and On-Screen Text
- How to Find Music and Pixel Art for Seasonal and Holiday Videos: Spring, Summer, Autumn, Winter, Christmas and New Year
- How to Choose Opening BGM for Your Videos: Hook Viewers in the First 5–10 Seconds
- How to Add BGM in Video Editing Software: Audio Track Basics (DaVinci Resolve, Premiere Pro, CapCut)


